torsdag 14. august 2014

7 saw controller board populated

I finished populating the 7 saw controller board tonight. It has not been tested yet but it looks good :-D

I didn't have any 22k 0204-size resistors, and I can't find any 3M3 or 4M7 resistors anywhere in that form factor, so I used normal 1% metal film ones instead. It looks a bit wonky but will work fine.

I have yet to test both the dual VCA and this board so not sure it works yet...

7 saw controller board

tiny LM13700 based dual VCA

Silk screen looks great :-)

Ingen kommentarer:

Legg inn en kommentar