Juno
The Juno filter seems to work fine as well. The output is +/- 500mV from a +/-5V input through a 230k input resistor.
The filter output is compensated on the voice card, with a gain of 5. This will however only get +/-2.5V from the input. Not sure what is going on there but it can be tested more thoroughly when testing with the voice card.
Edit: I misread the schematics, I put an external 230k resistor on the input when the Juno board already has one, meaning the input was attenuated by 50%
Resonance, VCA linear FM and cutoff CVs work fine. The 12/24dB switch has not been tested, neither has the temp sensor.
Moog
The Moog filter also works as it should. The range of the 2p and 4p trimmer CVs are sufficient, the reso balance trimmer needs around 4.6V for centering which is a bit too close for comfort.
The resonance CV at 5V may not be entirely sufficient for self oscillation but that has to be retested when the filter is connected to the voice card.
JP6
The JP6 filter works fine out of the box. I haven't checked the output levels but all filter variants look good and resonance works fine.
No comments:
Post a Comment